Enum nix::sys::termios::SetArg

#[repr(i32)]
#[non_exhaustive]
pub enum SetArg {
    TCSANOW,
    TCSADRAIN,
    TCSAFLUSH,
}

Specify when a port configuration change should occur.

Used as an argument to tcsetattr()

Variants (Non-exhaustive)

Non-exhaustive enums could have additional variants added in future. Therefore, when matching against variants of non-exhaustive enums, an extra wildcard arm must be added to account for any future variants.

TCSANOW

The change will occur immediately

TCSADRAIN

The change occurs after all output has been written

TCSAFLUSH

Same as TCSADRAIN, but will also flush the input buffer

Trait Implementations

impl Clone for SetArg

fn clone(&self) -> SetArg

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for SetArg

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Hash for SetArg

fn hash<__H: Hasher>(&self, state: &mut __H)

Feeds this value into the given Hasher.

fn hash_slice<H>(data: &[Self], state: &mut H)where
    H: Hasher,

Feeds a slice of this type into the given Hasher.

impl Ord for SetArg

fn cmp(&self, other: &SetArg) -> Ordering

This method returns an Ordering between self and other.

fn max(self, other: Self) -> Self

Compares and returns the maximum of two values.

fn min(self, other: Self) -> Self

Compares and returns the minimum of two values.

fn clamp(self, min: Self, max: Self) -> Selfwhere
    Self: PartialOrd<Self>,

Restrict a value to a certain interval.

impl PartialEq<SetArg> for SetArg

fn eq(&self, other: &SetArg) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl PartialOrd<SetArg> for SetArg

fn partial_cmp(&self, other: &SetArg) -> Option<Ordering>

This method returns an ordering between self and other values if one exists.

fn lt(&self, other: &Rhs) -> bool

This method tests less than (for self and other) and is used by the < operator.

fn le(&self, other: &Rhs) -> bool

This method tests less than or equal to (for self and other) and is used by the <= operator.

fn gt(&self, other: &Rhs) -> bool

This method tests greater than (for self and other) and is used by the > operator.

fn ge(&self, other: &Rhs) -> bool

This method tests greater than or equal to (for self and other) and is used by the >= operator.

impl Copy for SetArg

impl Eq for SetArg

impl StructuralEq for SetArg

impl StructuralPartialEq for SetArg